Product ID:MA-4062 ANCHOR ADHESIVE (PREVIOUSLY HT-4620)
MSDS Date:01/15/1992
FSC:8040
NIIN:01-291-9518
MSDS Number: BVVDY

PRATT & LAMBERT

76 TONAWANDA ST
BUFFALO, NY 14207
US

Emergency Phone: 716-873-6000

Info Phone: 800-647-2263

Cage: 77395

PRATT & LAMBERT

BUFFALO, NY 14207 US

Telephone: 800-647-2263

Cage: 77395

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 60%

OSHA PEL 200 PPM; Z-2

ACGIH TLV: S, 50 PPM; 9394

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

5-10 LB/GAL LESS WATER OR 612 G/L LESS

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGESTED:G/I
IRRITATION,NAUSEA,VOMITING. ASPIRATION HAZARD MAY BE FATAL.
INHALED:NOSE/THROAT IRRITATION,CNS
DEPRESSION,HEADACHE,DIZZINESS,NAUSEA,CONFUSION. EYES:IRRITATION.
SKIN:IRRITATION,DRYING. CHR ONIC:OVEREXPOSURE TO TOLUENE MAY CAUSE
LIVER, KIDNEY, LUNG & SPLEEN DAMAGE & TO SOLVENTS MAY CAUSE
PERMANENT CNS DAMAGE.
Explanation of Carcinogenicity:MFR LISTED NO INFORMATION ABOUT THE
CARCINOGENICITY OF THIS MATERIAL. HMIS DOES NOT EXPECT IT TO BE
CARCINOGENIC.
Effects of Overexposure:INGESTED:G/I IRRITATION, NAUSEA, VOMITING.
ASPIRATION HAZARD WHICH MAY BE FATAL. INHALED:NOSE/THROAT
IRRITATION, CNS DEPRESSION, HEADACHE, DIZZINESS, NAUSEA, CONFUSION.
EYES:IRRITATION. SKIN:IRRITATIO N, DRYING.
Medical Cond Aggravated by Exposure:NO INFORMATION GIVEN BY MFR ON
MSDS.

First Aid:OBTAIN MEDICAL ATTENTION IN ALL CASES. INGESTED:DON'T INDUCE
VOMITING. INHALED:REMOVE TO FRESH AIR. IF BREATHING STOPS,GIVE
ARTIFICIAL RESPIRATION. KEEP WARM & QUIET. EYES:FLUSH W/PLENTY OF
WATER. SKI N:REMOVE CONTAMINATED CLOTHING. WASH W/SOAP & WATER.
NOTE TO PHYSICIAN:ANY TREATMENT THAT MIGHT BE REQUIRED FOR
OVEREXPOSURE SHOULD BE DIRECTED AT CONTROL OF SYMPTOMS/CLINICAL
CONDITIONS.

Flash Point:40.0F,4.4C
Extinguishing Media:NFPA CLASS B EXTINGUISHERS. CO2, ALL PURPOSE DRY
CHEMICAL OR ALCOHOL FOAM, POLYMER FOAM IS PREFERRED FOR LARGE
FIRES.
Fire Fighting Procedures:WATER MAY BE INEFFECTIVE, BUT MAY BE USED TO
COOL EXPOSED CONTAINERS AND PREVENT AUTOIGNITION & EXPLOSION. IF
WATER IS USED, FOG NOZZLES ARE PREFERABLE.
Unusual Fire/Explosion Hazard:DURING EMERGENCY CONDITIONS OVEREXPOSURE
TODECOMPOSITION PRODUCTS MAY POSE A HEALTH HAZARD. SYMPTOMS MAY NOT
BE IMMEDIATELY APPARENT.GET IMMEDIATE MEDICAL ATTN.

Spill Release Procedures:KEEP SPECTATORS AWAY. ELIMINATE IGNITION
SOURCES. DIKE/CONTAIN SPILL W/INERT MATERIAL. TRANSFER LIQUIDS TO
COVERED METAL CONTAINERS FOR RECOVERY/DISPOSAL OR REMOVE W/INERT
ABSORBENT. USE ONLY NON-SPAR KING TOOLS. DON'T CONTAMINATE ANY
WATERSOURCE.
Neutralizing Agent:NO INFORMATION GIVEN BY MFR ON MSDS.

Handling and Storage Precautions:DON'T STORE ABOVE 115F (46C). STORE
LARGE QUANTITIES PER 29CFR1910.106.
Other Precautions:DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER USE. DO
NOT REUSE EMPTY CONTAINERS. GROUND CONTAINERS WHEN TRANSFERRING
LIQUID. DO NOT WELD, CUT, BRAZE, ETC. ON EMPTY CONTAINERS. DO NOT
USE PRESSURE TO EMPTY CONTAINER.

Respiratory Protection:RESTRICTED VENTILATION AREAS:NIOSH APPROVED
CHEMICAL CARTRIDGE RESPIRATOR. SPRAYING:MECHANICAL PREFILTER MAY
ALSO BE REQUIRED. IF TLV'S ARE EXCEEDED:PROPERLY FITTED NIOSH/MSHA
APPROVED RESPIRATOR W/AP PROPRIATE PROTECTION FACTOR.
Ventilation:PROVIDE LOCAL EXHAUST IN SUFFICIENT VOLUME & PATTERN TO
MAINTAIN EXPOSURES BELOW NUSIANCE DUST LIMITS & PEL/TLV.
Protective Gloves:SOLVENT IMPERMEABLE
Eye Protection:SAFETY GLASSES
Other Protective Equipment:NOT LIKELY TO BE NEEDED.
Work Hygienic Practices:MFR: ? HMIS:USE GOOD INDUSTRIAL HYGIENE
PRACTICE. AVOID UNNECESSARY EXPOSURE. WASH THOROUGHLY BEFORE EATING
OR DRINKING
Supplemental Safety and Health
MSDS ENTERED INTO THE HMIS BY DGSC AT REQUEST OF GSA.

HCC:F2
NRC/State Lic Num:NONE
Boiling Pt:B.P. Text:231F/111C
Vapor Density:>1
Spec Gravity:1
Evaporation Rate & Reference:SLOWER THAN DIETHYL ETHER
Appearance and Odor:NO INFORMATION GIVEN BY MFR ON MSDS.
Percent Volatiles by Volume:70

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS, ALKALINE MATERIALS
Stability Condition to Avoid:EXCESSIVE HEAT >115F/46C & IGNITION
SOURCES
Hazardous Decomposition Products:SMOKE, CARBON DIOXIDE AND CARBON
MONOXIDE
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DISPOSE OF I/A/W LOCAL,STATE, FEDERAL LAWS.
INCINERATE IN EPA PERMITTED FACILITY. DON'T INCINERATE CLOSED
CONTAINERS. CONTAMINATED ABSORBENT MAY BE DISPOSED IN HAZARDOUS
WASTE LANDFILL. PRODUCT AS PUR CHASED IS IGNITABLE AND HAS RCRA
CLASS D001.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.